1》 When setting the cutter, the setting hand wheel must be loosened first to make the setting lever contact the cutting point control switch, otherwise, when the cutter setting switch is turned to ON, the set action cannot be generated.

2》 During operation, the cutter shall be placed in the center of the upper platen as far as possible to avoid unilateral wear of the machine and affect its service life.

3》 Replace with a new cutter. If the height is different, reset it according to the setting method.

4》 When cutting, please leave the knife or board with your hands. It is strictly forbidden to use your hands to help the knife mold to cut, so as to avoid danger.

5》 If the operator needs to leave the position temporarily, be sure to turn off the motor switch to avoid damage to the machine due to improper operation by others.

6》 Please avoid overloading to avoid damaging the machine and reducing its service life.